Rot1Prog - Functions

Front panel:



Buttons:

• - CCW
• - CW
• - Setup mode
• - Function mode

Driver functions
Pressing an [F] button, you choosing the functions:

• [ ] - hand work;
• [H] - half automatic work (writing a value of angle without turning a rotor after (2s) the rotor automaticaly starts to task angle;
• [A] - automatic work (full PC controlling by Spidlog software).

Additional functions for the "Canada" version:

• [P] -  memory function (6 angles setup memory. You can choose on mouse buttons). ATTENTION! The mouse is not a computer mouse, so please don't plug it into your computer!!!

Setup mode ("Canada" version)

You only can choose this function [S] when the programmer is on HAND WORK option. Every click on the [S] button gives you the the following options:

• [  ] - choosing rotor transmission (1.00-RAU;0.66-RAK) or option (P) when it is possible to insert a transmission from Spidloc software)
• [PH] - maximal rotor stock setup (not more then +180 degree)
• [PL] - minimal rotor stock setup (not less then -180 degree)
• [P blink] - zero value of rotor setup (only use when clearing the controller)
• [P] - setting up value of angles for memory from P1 to P6

[S] chooes consecutive functions [<] [>].

RESET

Shut down the controller with pressing the [F] button. Shut down currently supplies. Driver moves to HAND WORK option shows zero.

Back panel
 

• Cut-out (FUSE)
• Power lead
• Power button
• M - Power for engine (1 and 2).
• I - Impuls input (3 and 4).
• DB9 (male) - Mouse input
• DB9 (female) - PC output